GGoodDock

GoodDock Blog

Old Photo Restoration Checklist: Before You Scan Anything

The box of old photos in the closet is on a timer. Heat, damp air, and plain handling eat a little more color every year, and a cracked print never comes back. An old photo restoration checklist fixes the order: sort first, handle gently, clean only what needs it, then scan once and scan right.

Most people do it backward. They plug in the scanner, feed in a stack, and discover halfway through that half the prints are duplicates, a quarter are strangers nobody can name, and one fragile panorama just tore along a fold. Slow down. The scanner is the last step, not the first. Slow down.

Sort prints into keepers and discards before scanning anything. Handle prints by the edges, clean only with a dry microfiber cloth, and scan at 600 dpi TIFF for prints you plan to reprint. Store the originals flat in acid-free boxes afterward, and keep two copies of every scan in different places.

Sort First: Keepers, Maybes, and Gone

Sorting feels like delay. It saves the most time in the whole project. A scanner does not care what it scans, so every blurry duplicate and mystery landscape you feed it becomes a file you must name, store, and sort later anyway.

Work in small batches on a clean table. Three piles, no fourth pile. The maybe pile has a deadline: if nobody can name the people or place after one phone call to a relative, it goes. Three piles. No exceptions.

  • Keepers: sharp, identified, or the only copy of a person or event.
  • Maybes: good photos with missing names, dates, or places, pending one quick check.
  • Gone: exact duplicates, thumbs over lenses, and blank or ruined frames.
  • Label as you sort: pencil on the back, never pen, with names and a year.
  • Set aside: fragile, curled, or stuck-together prints for gentler handling.
  • Count the keepers: the total sets your scanning time and storage needs.

Handle Faded Prints Without Wrecking Them

Old prints are thinner and drier than they look. Fingers leave oils that show up years later as fingerprints baked into the surface. Edges chip. Corners snap. Treat every print like it has already survived longer than it was built to.

Wash and dry your hands first, then hold prints by the edges with both hands. Support large prints from underneath instead of pinching one corner. Never force apart prints that are stuck together; humidity and time glued them, and pulling tears the image layer. A conservator can separate them safely. Edges only. Both hands.

  • Edges only: fingertips never touch the image surface.
  • Flat transport: carry prints in a folder or tray, never folded in a hand.
  • No metal: paper clips rust and rubber bands melt into prints.
  • One at a time: stacks slide against each other and scratch.

Clean Prints and Slides the Safe Way

Dust is the main enemy, and it is also the easiest to beat. A dry microfiber cloth, wiped in one direction, lifts loose dust without grinding it across the surface. Compressed air works too, if you hold the can upright and keep it far enough back that no cold propellant hits the print.

What you must not do matters more. Water warps paper. Household cleaners dissolve coatings. Erasers meant for pencil leave crumbs and abrasion. If a print has mold, water stains, or insect damage, put it in its own sleeve and set it aside for a professional. That print is exactly the one worth paying to save. When in doubt, stop.

A photo restoration supplies checklist is short: microfiber cloths, acid-free boxes, sleeves, and a pencil.

  • Dry cloth only: microfiber, one direction, light pressure.
  • Slides need care too: blow dust off, never wipe the film side hard.
  • Gloves optional: clean dry hands beat clumsy cotton gloves for grip.
  • Skip the chemicals: no water, no sprays, no erasers on photo surfaces.

Scan Settings That Actually Matter

Resolution is the one setting you cannot fix later. Scan prints at 600 dpi and save the master file as a TIFF. A TIFF keeps every pixel the scanner captured, while a JPEG throws detail away each time it saves. Keep the JPEGs for sharing, but keep the TIFFs as masters.

Name files as you scan, not later. Year, then person or event, then a sequence number: 1962-mom-graduation-01. Future you will be grateful. So will anyone else who inherits the archive. Scan the backs too when they carry handwriting; that note is often the only record of who is in the picture. Check each scan. Then move on.

This scan old photos checklist works for prints, slides, and negatives alike.

  • Prints: 600 dpi, color, TIFF master plus a JPEG copy.
  • Small prints and slides: higher resolution, since enlarging magnifies flaws.
  • Negatives: scan the negative when you have it; it holds more detail than the print.
  • Backs with writing: scan them and keep the pair together in the same folder.
  • Color mode: color even for black-and-white prints, to catch tones and stains.
  • Check each scan: zoom in once before moving on, and rescan mistakes now.

After the Scan: Files, Backups, Originals

Scanning is only half the rescue. Files on one hard drive are one spilled coffee from gone. Use the 3-2-1 rule: three copies, on two different kinds of storage, with one copy somewhere else. A computer plus an external drive plus a cloud folder covers it for most families.

Originals still matter. Store them flat in acid-free boxes, in a lived-in room, not an attic or basement where heat and damp swing wildly. The scan is the working copy. The original is the proof.

I turned this into a free printable old photo restoration checklist — get the free checklist. It pairs with the 58-page Photo Organization System, which adds 4 Excel sheets for tracking every batch, box, and backup. Print the checklist, tape it to the scanner, and work through the box in order. One copy is none.

  • Three copies: computer, external drive, and one off-site copy.
  • Two media types: do not keep every copy on the same kind of drive.
  • One off-site: a cloud folder or a drive at a relative's house.
  • Originals flat: acid-free boxes, cool and dry, out of sunlight.

Should I scan old photos at 300 or 600 dpi?

Scan everyday prints at 600 dpi and save the master as a TIFF. That resolution holds up for reprints up to roughly double the original size, which covers most family uses. Reserve 300 dpi for quick sharing copies only, since a low-resolution scan cannot gain detail later. Small prints, slides, and negatives deserve higher settings, because enlarging a tiny original magnifies every flaw.

Can I clean old photos with water?

No. Water soaks into old paper, warps it, and can lift emulsion right off the surface, so keep prints dry. A soft, dry microfiber cloth removes surface dust safely. If a print has stuck-on grime, mold, or water damage, stop and ask a photo conservator instead of improvising. A ruined original cannot be rescanned, and a careful pause costs nothing.

What is the best way to store original prints after scanning?

Store originals flat, upright in acid-free boxes or sleeves, in a cool, dry room away from attics and basements. Keep them out of direct sunlight and away from rubber bands, paper clips, and sticky notes, which all leave marks over time. Label boxes on the outside, not on the prints. Good storage matters as much as a good scan, because the original remains the backup of last resort.

Do I need to restore old photos before scanning them?

Basic restoration, like dust removal and gentle flattening under weight, helps scans come out cleaner. Skip chemical treatments, bleaching, and aggressive retouching before scanning, since those steps can damage the original and cannot be undone. Scan first, then fix color and scratches on the digital copy. The scan preserves the current state, and the digital file takes all the risk from then on.